
Contents
Standard garage door sizes are 8 or 9 feet wide by 7 feet tall for a single door and 16 feet wide by 7 or 8 feet tall for a double door, with 18 and 20 foot widths for larger vehicles. RV doors are usually 10 to 14 feet wide and 12 to 14 feet tall.
This guide lists the standard garage door sizes for single, double and RV doors, explains the clearances an installer checks, and shows how to take accurate garage door measurements in about ten minutes.
Standard Garage Door Sizes: Key Takeaways
Standard garage door sizes are written width first, then height. Older California tract homes built before the 1980s often have 7-foot-tall doors, while many newer homes use 8-foot doors so taller vehicles fit.
The most common single garage door size is 8 or 9 feet wide by 7 feet tall; newer homes often use 8-foot-tall doors.
The most common double garage door size is 16 feet wide by 7 or 8 feet tall, with 18 and 20 foot widths for larger vehicles.
RV and boat doors are usually 10 to 14 feet wide and 12 to 14 feet tall.
Always measure the finished opening plus headroom, side room and backroom before ordering.
Typical residential garage door sizes
| Door type | Common widths | Common heights | Typical use |
|---|---|---|---|
| Single | 8 ft, 9 ft, 10 ft | 7 ft, 8 ft | One car, compact SUV |
| Double | 16 ft, 18 ft | 7 ft, 8 ft | Two cars side by side |
| Oversized double | 20 ft | 8 ft | Two large trucks or a car plus workspace |
| RV / boat | 10 ft to 14 ft | 12 ft to 14 ft | Motorhomes, boats on trailers |
| Golf cart / storage | 5 ft to 6 ft | 7 ft | Side bays, carts, motorcycles |
What Is the Standard Size of a Single Garage Door?
A single garage door size is typically 8, 9 or 10 feet wide. An 8 foot width fits a compact car with little room to spare, while 9 feet is the comfortable minimum for most SUVs and lets you open doors without scraping mirrors.
Heights are usually 7 or 8 feet. If you drive a lifted truck, a van or carry a roof box, the extra foot of an 8-foot-tall door is worth checking for before you buy a new vehicle, not after.
| Single door size | Best for |
|---|---|
| 8 x 7 ft | Compact and midsize cars, older homes |
| 9 x 7 ft | Most cars and small SUVs |
| 9 x 8 ft | SUVs with roof racks, taller vans |
| 10 x 8 ft | Full-size pickups and wide vehicles |
If your garage has two single doors, a 9 foot width on each gives most drivers more room than a single 16 foot double door, because the center post keeps each car in its own lane.
What Is the Standard Size of a Double Garage Door?
The standard double garage door size is 16 feet wide. A 16 foot garage door parks two sedans or small SUVs side by side, but it leaves little space between mirrors, so many homeowners upgrade to 18 feet when the framing allows.
A 20 foot double garage door is less common and is usually found on newer custom homes or three-car garages. Like single doors, double doors come in 7 and 8 foot heights.
Choose the width by the vehicles you park and how much room you want to open doors and walk past mirrors. The common double sizes compare like this:
16 x 7 ft: the standard on many older California tract homes; fits two sedans.
16 x 8 ft: same width with room for taller SUVs and vans.
18 x 7 or 18 x 8 ft: extra space between vehicles, helpful with a full-size truck.
20 x 8 ft: fits two large trucks or a car plus a workshop area.
Wider double doors weigh more, so they need heavier springs and a capable opener. A professional sizes the springs to the door's weight during installation.
Specialized Garage Door Size Categories
Custom sizes cost more than standard garage door sizes and take longer to arrive, usually several weeks. They make sense when you are widening an opening during a remodel, matching a historic home, or fitting a door into a garage converted from another use.
If your opening is within an inch or two of a standard size, the framing can often be adjusted so a standard door fits, which is usually cheaper than ordering a custom panel set.
Beyond single and double doors, manufacturers build RV garage door sizes, typically 10 to 14 feet wide and 12 to 14 feet tall, as well as narrow 5 to 6 foot doors for golf carts, motorcycles and side storage bays.
Taller doors may need a high-lift or vertical-lift track system when the ceiling is high, and our guide to high lift garage doors explains how those work.
What Size Garage Door Do You Need for Your Vehicle?
Add at least 2 feet beyond the vehicle's mirror-to-mirror width so you can pull in without guiding yourself inch by inch.
Suggested door size by vehicle
| Vehicle | Suggested width | Suggested height |
|---|---|---|
| Compact or midsize car | 8 to 9 ft single | 7 ft |
| Full-size SUV or minivan | 9 to 10 ft single | 7 ft, 8 ft with roof rack |
| Full-size pickup | 10 ft single or 18 ft double | 8 ft |
| Two vehicles side by side | 16 to 18 ft double | 7 to 8 ft |
| RV, boat or trailer | 12 to 14 ft | 12 to 14 ft |
Height matters for roof racks, cargo boxes and lifted trucks. Measure your tallest vehicle with any racks attached and allow a few inches of clearance below the bottom of the open door, not just the opening. An opener rail or a low-hanging door panel can reduce usable height.
How Do You Measure a Garage Door Size?
Measure the finished opening's width and height, then the headroom, side room and backroom around it. The opening is only half the story. A sectional door rolls up into the garage on tracks, so the space above and beside the opening matters just as much.
Garage door headroom is the clearance most often overlooked. Measure it before choosing a spring system or opener, because low headroom changes the hardware you can use.
Step-by-Step Measurements
Measure the width of the finished opening at its widest point, from the inside of one jamb to the other.
For height, measure from the floor to the underside of the header in the center and at both sides. Use the smallest number.
Then measure headroom from the top of the opening to the lowest point above it.
Check side room on the left and right, from the opening to the nearest wall or obstruction.
Finally, measure backroom from the header wall to the back wall or the first obstruction in the ceiling.
Photograph the header and side jambs. Rot or cracks in the framing should be repaired before a new door goes in.
Space an installer checks around the opening
| Clearance | Where it is measured | Typical minimum | If you are short |
|---|---|---|---|
| Headroom | Top of the opening to the ceiling or lowest obstruction | About 12 in for standard torsion hardware | Low-headroom track kits can work with roughly 4.5 to 6 in |
| Side room | Edge of the opening to the side wall, each side | About 3.75 in to 5 in | Narrow-jamb brackets or a smaller door |
| Backroom | Header wall back into the garage | Door height plus about 18 in | More is needed for a rail-style opener; check its rail length |
Not sure about your numbers? A professional can measure during a quote visit and confirm whether a standard size will fit. See our garage door replacement and installation guide for what happens next.
HOA and Building Code Requirements for Garage Door Sizes
The California building code does not set a minimum garage door size for homes, but it does regulate structural headers, wind loads and fire separation between the garage and living space. Changing the rough opening, the framed hole before trim, generally needs a permit.
For example, converting two single doors to one double means removing the center post and installing a longer engineered header. That usually requires a permit and sometimes an engineer's letter.
Homeowners associations are often stricter than the city's building code. Many California HOAs specify allowed door widths, heights, styles and colors, so get written approval before you order a door in a new size.
In wildfire-prone areas, some cities and HOAs also have requirements for exterior materials and gaps around the door, which can affect the door you order. Ask about any local rules when you check sizes. If you are changing the door style as well as the size, our guide to types of garage doors helps you shortlist options your HOA is likely to approve.
Frequently Asked Questions About Garage Door Sizes
What is the most common single garage door size?
An 8 or 9 foot wide door that is 7 feet tall is the most common single door on older homes. Newer homes frequently use 8-foot-tall doors so taller vehicles fit. An 8 foot width fits a compact car with little room to spare, while 9 feet is the comfortable minimum for most SUVs.
Is a 16 foot door big enough for two cars?
Yes for most sedans and small SUVs, although a 16 foot door leaves little space between mirrors. If you park two full-size trucks or want room to open doors comfortably, an 18 foot door is easier to live with. A 20 foot door fits two large trucks or a car plus a workshop area.
Can I make my garage door opening taller?
Often, but it means changing the header, which is structural work that usually needs a permit. Ask for a framing assessment before ordering a taller door. Also check headroom, since the tracks and springs need space above the opening, and get written HOA approval first if your association sets door sizes.
Does garage door size affect home value?
Indirectly. A larger door that fits modern trucks and SUVs makes a garage more usable, and garage door replacement is consistently one of the best-returning exterior upgrades. So size a new door for the vehicle you expect to own in the next few years, not only the one you drive today.
What are the rough opening dimensions for standard garage door sizes?
For most sectional doors the rough opening matches the door size, for example 16 by 7 feet for a 16 by 7 door. The door overlaps the stops slightly to seal, so do not oversize the opening.
Do building codes specify a minimum garage door size?
No residential minimum is set by the California building code. Codes cover the header, wind resistance and fire separation between the garage and living space, while HOAs may set size and style rules. Changing the rough opening generally needs a permit, so check with your local building department before ordering a door in a new size.
How much headroom does a garage door need?
About 12 inches of headroom, measured from the top of the opening to the ceiling or lowest obstruction, is typical for standard torsion hardware. Low-headroom track kits can work with roughly 4.5 to 6 inches. You also need about 3.75 to 5 inches of side room on each side, and backroom equal to the door height plus about 18 inches.
Sources & References
- DASMA – Technical Data Sheet #160: Sectional Garage Door Terminology. Standard names for door parts and dimensions (checked November 2026)












