A garage door seal keeps out dust, rain, pests and heat. Seal types, benefits, warning signs, DIY vs. professional installation and maintenance.
Contents
A garage door seal is a rubber or vinyl strip that closes a gap around a garage door. Most doors use a bottom seal, side and top weatherstripping and, on uneven floors, a threshold seal. Seals keep out dust, rain, pests, heat and wind-blown embers, and replacing worn ones is one of the most cost-effective garage upgrades.
This guide explains the types of garage door seals, the benefits of keeping seals in good shape, the signs that a seal is worn out, how DIY and professional installation compare and how to make new seals last.
Key Takeaways
A bottom seal slides into a retainer on the door, a threshold seal is glued to the floor and weatherstripping seals the sides and top.
Check for worn seals by closing the door on a sunny day and looking for daylight around the edges.
Seals often last 3 to 6 years, and less on doors that face strong afternoon sun.
Most bottom, threshold and perimeter seals are DIY jobs, but anything involving the bottom bracket or cables belongs to a technician.
In wildfire-prone areas, tight seals help keep embers out of the garage.
Types of Garage Door Seals: Which One Do You Need?
Seal
Where it goes
What it fixes
Bottom seal (astragal)
Retainer on the bottom of the door
Gaps at the floor, drafts, pests
Threshold seal
Glued to the garage floor
Uneven floors, water running in
Perimeter weatherstripping
Door stop on sides and top
Light and drafts around the edges
Section seals
Between door panels
Air leaks between sections
Brush seals
Sides of rolling or commercial doors
Debris and pests
Start by closing the door and looking for daylight from inside the garage. Light at the floor points to the bottom or threshold seal, while light at the edges points to the side and top stops.
The main types of garage door seals are bottom seals that slide into a retainer on the door, threshold seals fixed to the floor, and side and top weatherstripping fastened to the frame. Each closes a different gap, so the right one depends on where you see light or feel a draft. Before buying any of these types of garage door seals, match the retainer profile on your door so the new seal fits.
Bottom Seals
A bottom seal is a rubber or vinyl strip that slides into an aluminum retainer along the bottom edge of the door. It compresses against the floor when the door closes. For example, most residential doors use a T-type or bulb seal, and the width must match the door width.
Bottom seals come in different shapes (T, bulb, J and beaded) to fit the retainer on your door. So pull out a piece of the old seal and match the profile, or measure the retainer channel before ordering.
To find the right size, measure the full width of the door and check the shape of the retainer channel on the bottom of the door. Then match the seal profile, such as T-type or bulb, and the width of the flanges that slide into the retainer. Taking a short piece of the old seal to the store is the easiest way to get an exact match.
Side and Top Seals
Side and top seals, also called perimeter weatherstripping or door stops, are vinyl strips with a soft flap that seal the edges of the door against the frame. They also come in standard lengths for the sides and the header.
Perimeter weatherstripping is nailed or screwed to the door stop along the sides and top. The flexible flap presses against the door face when closed to block light, drafts and dust.
In hot inland areas, sun-facing stops can harden and crack sooner than shaded ones. Vinyl stops with a rigid backing hold their shape better than all-rubber strips and are easy to replace when the flap wears out.
Benefits of Installing Quality Garage Door Seals
Quality garage door seals keep the weather and pests out, make an attached garage more comfortable and protect the things stored inside. They are among the lowest-cost improvements you can make to a garage door.
Keeps out rain, dust and leaves.
Blocks rodents, insects and other pests.
Improves comfort and energy efficiency in attached garages.
Reduces noise from outside.
Helps keep embers out in wildfire-prone areas.
Seals also work together with insulation. An insulated door with worn seals still leaks air at the edges, so if you are upgrading with garage door insulation, replace the seals at the same time. During Public Safety Power Shutoffs, a well-sealed garage also holds its temperature better, which helps if you store food or medication in a garage freezer or refrigerator.
Do Seals Keep a Garage Cooler?
They help. Seals block hot outside air from leaking in around the edges, which is useful in inland California heat. However, on their own they do not stop heat passing through the door panels. So for a noticeably cooler garage, pair new seals with an insulated door or insulation kit and keep the door closed during the hottest hours.
How Do You Know When a Garage Door Seal Needs Replacing?
A garage door seal needs replacement when it no longer closes the gap completely. The simplest check is to close the door on a sunny day, turn off the lights and look for light around the edges.
You see daylight under or around the door.
The rubber is cracked, flattened or brittle.
Water, leaves or insects get into the garage.
Dust collects in a line along the floor inside.
Also look for seals that have pulled out of the retainer, bottom seals torn by debris and side stops with a gap where the door no longer touches them. If the door bounces back up when it reaches the floor after a new seal is installed, the opener's close limit may need adjustment. Our guide to a garage door that won't close covers other causes.
Garage Door Seal Installation: DIY vs. Professional Options
Most garage door seal installation can be done by a homeowner, but a professional is a good choice when the retainer is damaged, the opener needs adjusting or the seal is near the bottom brackets. Here is how the two options compare.
Benefits and Drawbacks of DIY Installation
Bottom seals that slide into a retainer and threshold seals are manageable DIY jobs with basic tools. However, the challenge is matching the profile and getting the new seal fully seated.
Benefits: low cost, only basic tools needed, can be done in an afternoon.
Drawbacks: matching the right profile can take trial and error, feeding a long bottom seal through a dry retainer is awkward, and a bent retainer may need replacing.
For step-by-step instructions, see our guide on how to replace garage door seals, which covers the bottom seal, side and top stops and threshold seals.
Benefits and Drawbacks of Professional Installation
A technician brings the right profile, replaces bent retainers and adjusts the opener's close limit so the door seals without bouncing back. It costs more but is often done with a tune-up.
Benefits: correct parts on the first visit, replacement of damaged retainers, opener limit and safety reversal checked.
Drawbacks: higher cost than DIY, and you need to schedule a visit.
Seal replacement is often included in a garage door tune-up, which can make it better value.
How Do You Make Garage Door Seals Last Longer?
To make garage door seals last, keep them clean, keep them out of harsh conditions where possible and inspect them twice a year. A few minutes of care can add years to a seal's life.
In short, clean seals twice a year, keep heavy items off the bottom seal, apply a silicone protectant if the manufacturer recommends it and replace sun-damaged sections before they crack through.
Wipe the seals with mild soap and water, never solvents or petroleum products that soften rubber.
Clear leaves, gravel and debris from the floor so the bottom seal is not torn.
Check seals before the rainy season and again at the start of summer.
In wildfire-prone areas, inspect seals for gaps every year, since even small openings can let embers in.
Common Questions About Garage Door Seals
These answers cover the questions homeowners ask most about choosing, installing and replacing a garage door seal.
How often should garage door seals be replaced?
Often every 3 to 6 years, sooner on doors that face strong afternoon sun. Inspect them twice a year, before the rainy season and at the start of summer, and replace any seal that is cracked, flattened or brittle. Daylight under or around the closed door, or a line of dust along the floor inside, also means it is time.
Can I install a garage door seal myself?
Yes for most bottom, threshold and perimeter seals. Bottom seals slide into a retainer, and side and top stops are nailed or screwed to the door stop, so basic tools are enough. However, a bent retainer may need replacing. Leave anything involving the bottom bracket or cables to a technician, because those parts are under spring tension.
What’s the difference between a threshold seal and a bottom seal?
A bottom seal is attached to the door and slides into an aluminum retainer along its bottom edge. A threshold seal, by contrast, is glued to the garage floor. The bottom seal compresses against the floor when the door closes. The two are often used together on uneven floors or where water runs in.
What’s the best garage door seal for keeping out water?
A threshold seal combined with a good bottom seal works best, especially on driveways that slope toward the garage. The threshold seal is glued to the floor and blocks water running in, while the bottom seal compresses against the floor when the door closes. Also check the side and top weatherstripping, since gaps at the edges can let rain blow in.
Can a garage door seal help with pests?
Yes. Gaps under and around the door are a common entry point for rodents, insects and other pests. A tight bottom seal, intact side and top stops and, on uneven floors, a threshold seal close most of those gaps. Replace seals that have been chewed or torn, and check the corners, where small gaps often remain.
Why does my garage door bounce back up after I install a new seal?
The opener's close limit probably needs adjustment. When a door bounces back up as it reaches the floor after a new seal goes on, the limit no longer suits the new seal. A technician can adjust the close limit so the door seals without bouncing back, then check the safety reversal. If the problem continues, look for other causes of a door that won't close.