7 Signs Your Garage Door Springs Are Bad or Broken

Published:
Last updated:
Reading time:
13 minutes

Seven clear signs your garage door springs are going bad, the dangers of DIY spring repair, maintenance tips and what replacement costs.

garage door springs are going bad
Contents

When garage door springs are going bad, the door feels heavy, rises unevenly, opens only a few inches or closes too fast. Other signs are a loud bang, a visible gap in the spring coil, and rust or stretching. A broken spring leaves the door's weight unsupported, so broken garage door spring replacement is a job for a technician.

Key Takeaways

  • Most standard springs are rated for about 10,000 cycles, roughly 7 to 10 years for most households.

  • A gap of an inch or two in a torsion spring coil, or a loud bang from the garage, usually means a broken spring.

  • A door that feels heavy by hand, hangs crooked or slams shut has lost spring support.

  • Homeowners can do visual checks, a door balance test and lubrication, but removal and winding are for a trained technician.

  • On a two-spring door, replace both springs together; a pair of torsion springs typically costs $200 to $450 installed.

What Do Garage Door Springs Do?

Garage door springs are the parts that do the heavy lifting. A typical door weighs well over 100 pounds, and the springs carry most of that weight so the opener and your arms only guide the movement.

Springs balance the door's weight so it feels light. Torsion springs sit above the door on a shaft; extension springs run beside the tracks. However, both wear with every cycle.

Most standard springs are rated for about 10,000 cycles, where one cycle is one opening and one closing. As the steel fatigues, the spring slowly loses strength before it finally breaks. That gradual loss is why the warning signs below often appear weeks before a failure. Learn more about each system in our guides to garage door torsion springs and garage door extension springs.

Springs rarely fail without warning. Each cycle fatigues the steel a little more, so the signs that garage door springs are going bad usually build up over weeks or months: a door that feels heavier, a slower or uneven rise, or new creaks. Noticing those early changes gives you time to schedule a replacement instead of dealing with a door that will not open on a busy morning.

How Do You Know If Garage Door Springs Are Going Bad?

You can tell garage door springs are going bad when the door is hard to lift, rises crooked, makes a loud noise, shows a gap in the coil, closes too fast, stops after a few inches or shows visible wear. Some mean the spring is already broken, while others mean it is weakening. The table gives a quick sense of how urgent each type of sign is.

SignSeverityAction
Gap in the springHighStop using the door, call for service
Door heavy by handMediumSchedule service soon
Slow or jerky startLow to mediumCheck balance and lubricate

1. Door Won't Open or is Difficult to Lift

If the door feels very heavy by hand or the opener strains, the springs are no longer carrying the load.

To check, close the door, pull the emergency release cord and try lifting the door by hand. A healthy spring system makes a single-car door feel like it weighs only a few pounds. If you can barely lift it, or it will not stay up, the springs are weak or broken. Do not keep running the opener, because it is not built to carry the door's full weight.

2. Uneven Movement or Crooked Garage Door

One side rising faster than the other points to a weak spring or a cable problem.

On extension spring doors, a weak spring on one side lets that side lag behind. On torsion doors, a broken spring in a two-spring setup or a cable that has slipped off its drum can make the door hang crooked. A tilted door can bind in the tracks and bend panels, so stop using it and have the springs and lift cables inspected.

3. Loud Noise When Operating the Door

Creaking and popping can mean worn springs; a single loud bang often means one has broken.

Dry or worn springs often squeak or creak with each movement, and lubrication can quiet them. A sudden bang that sounds like a gunshot, often when nobody is using the door, is the classic sound of a torsion spring snapping. If you hear it, check for a gap in the coil before you try to open the door.

4. Visible Gaps in the Springs

With the door closed, look at the spring above the opening. A healthy torsion spring is one tight, continuous coil, but a broken one shows a clear separation, usually with the two halves slightly unwound. On extension springs, look for coils that have spread apart while the door is open. A gap means the door has lost most of its lifting support.

To check safely, look but don't touch:

  1. Unplug the opener so nobody runs it while you look.

  2. From inside the garage, find the spring or springs on the metal bar (the torsion tube) just above the door.

  3. Follow each spring from end to end and look for a gap in the coils or a section that has spun loose.

  4. Look at the lift cables on each side. A cable lying slack or off its drum points to lost spring tension.

Don't lift the door to test it, and don't touch the spring, the winding cones at its ends, the bottom brackets or any set screws: even with one spring broken, the parts around it can still be under tension. If the door is stuck open when a spring breaks, keep people, pets and cars out from under it and don't pull the emergency release, because with no spring holding it the door can drop.

5. Garage Door Closes Too Quickly

A balanced door lowers smoothly and settles gently on the floor. If it speeds up in the last stretch or hits the ground hard, the springs are no longer slowing its descent. This is a safety risk for people, pets and cars, and it can damage the bottom section and the opener over time.

6. Garage Door Opens Only a Few Inches Then Stops

Most modern openers sense excess force and stop or reverse to protect the motor. When a spring breaks, the opener feels the full weight of the door and gives up after a few inches. The opener light may flash as well. This is a spring problem, not an opener problem, so resetting or adjusting the opener will not fix it.

7. Visible Damage or Wear on Springs

Rust is common in coastal California, where salt air reaches the garage, and it weakens the steel over time. In hot inland areas, check springs that look stretched or misshapen. After an earthquake, look for cables that have shifted on the drums or pulleys. So any visible damage is a reason to book an inspection.

Why Do Garage Door Springs Break?

Springs are made to wear out. Every time the door opens and closes, the spring winds and unwinds once, and after enough cycles the steel fatigues and fractures. The cycle rating is only part of the story: DASMA's technical data sheet on spring cycle life lists the factors that decide how long a spring lasts in practice.

  • How often the door runs: a household using the door eight times a day uses up a spring's cycles four times faster than one using it twice.

  • Whether the spring was sized for the door: a spring that is too small for the door's weight works harder on every cycle.

  • Rust and dryness, which add friction and stress between the coils, especially near the coast.

  • Temperature swings, one reason many breaks happen on cold mornings.

So age alone doesn't tell you when a spring will break; how much the door is used matters more.

Torsion or Extension Spring: Which One Broke?

Torsion springs sit on a metal bar directly above the door and twist as it moves. Extension springs run along the horizontal tracks on each side and stretch as the door closes. A broken extension spring often hangs loose from the track, held only by a safety cable threaded through it. If your door has extension springs without safety cables, mention it to the technician.

Is It Safe to Replace Garage Door Springs Yourself?

No. DIY spring repair is dangerous because the spring stores enough energy to break bones, and that energy is released during removal and winding. The risk applies to both torsion and extension systems, though torsion springs carry more energy.

Torsion springs hold enough energy to cause serious injury when released incorrectly. Winding requires proper winding bars and exact turn counts. Spring replacement is a job for a trained technician.

If you suspect your garage door springs are going bad, safe tasks for homeowners include visual checks, balance tests and lubrication. Leave removal, winding, cable and drum work to a technician, who will usually replace both springs and check the cables and bearings at the same visit. Our guide to garage door spring replacement explains what that visit includes.

When you call, say whether the door has one spring or two and whether it is open or closed, so the provider brings the right parts. Ask for a written quote that lists the spring size and cycle rating, and whether the cables or rollers are being replaced too.

How Can You Make Garage Door Springs Last Longer?

Regular maintenance helps springs reach their full cycle rating and it makes worn springs easier to spot early. Use a garage door lubricant rather than heavy grease, and wipe off any excess. Our guide on how to lubricate a garage door covers products and technique.

Lubricate springs every six months, test door balance twice a year and watch for these warning signs:

  1. A loud bang from the garage.

  2. A visible gap in a torsion spring coil.

  3. Lifting the door by hand feels very heavy.

  4. The door rises a few inches and stops.

  5. It closes too fast or slams.

  6. Uneven lifting leaves the door looking crooked.

  7. Cables are loose or have jumped off the drums.

A simple door balance test tells you a lot about spring health. With the door closed, pull the emergency release cord to disconnect the opener, then lift the door by hand to about halfway and let go. A door that stays put has good door balance. If it drops toward the floor or rises on its own, the springs need adjustment by a technician. Reconnect the opener when you are done.

Common Questions About Garage Door Springs

Do springs always break with a bang?

Torsion springs usually do. When a torsion spring snaps, it often makes a loud bang like a gunshot, sometimes when nobody is using the door. Extension springs, however, may simply stretch out and lose strength, so watch for coils that have spread apart or a door that feels heavier. Either way, stop using the door and call a technician.

How long do garage door springs last?

Standard springs are rated around 10,000 cycles, about 7 to 10 years for most households. One cycle is one opening and one closing, so a busy household wears springs out sooner. High-cycle springs last much longer. Also, rust from coastal salt air and skipped lubrication can shorten a spring's life.

How much does spring replacement cost?

Typically $200 to $450 for a pair of torsion springs installed, more for high-cycle or heavy doors. Prices vary with the door's size, weight and configuration, the parts needed and local labor rates. A technician usually replaces both springs and checks the cables and bearings at the same visit, so ask for a written quote first.

Can cold weather affect garage door springs?

Yes. Cold makes steel more brittle, so springs near the end of their life often break on cold mornings. A spring that has already lost strength over years of cycles has little margin left. So if your springs are old or rusty, or the door feels heavy, have them inspected before a cold snap rather than waiting for a failure.

Is it safe to open a garage door with a bad spring?

No. A weak or broken spring leaves the door's full weight on the opener and on anyone lifting it. The door may fall suddenly or move unevenly and bind in the tracks. Unplug the opener, keep people and pets away from the door and call a technician.

Should both springs be replaced if only one is bad?

Yes, in most cases. On a two-spring door, both springs have run the same number of cycles, so the second one is usually close to failing. Replacing both keeps the door balanced and avoids paying for a second service visit a few weeks or months later.

How do I know what size torsion spring my door needs?

Springs are matched to the door's weight and height by wire size, inside diameter, length and wind direction. Manufacturers mark wire size with standard DASMA color codes, but the reliable way is for a technician to measure the old spring and weigh or calculate the door. Don't choose a spring by door size alone.

Sources & References

  1. DASMA – Technical Data Sheet #190: Factors Affecting Spring Cycle Life. Why a spring's real life differs from its cycle rating (checked November 2026)
  2. DASMA – Technical Data Sheet #171: Official Color Codes for Torsion and Extension Springs. Identifying spring wire size by color code (checked November 2026)